Zhejiang Anji Tianyang Rotational Mouding Machinery Co.,Ltd

High quality product, professional service, being the core supplier in laser industry!

Home > News > Content
Rotomolding Machine Rotational Molding
- Nov 01, 2017 -

Rotomolding Machine Rotational molding

Molding machine excellent high temperature performance and oxidation stability, to prevent grease high temperature deterioration, to ensure that the lubrication of high temperature long-term normal work; excellent adhesion performance, good mechanical stability and colloidal stability, to ensure that the lubrication site and will not be lost ; Good lubricity, protection of bearings to reduce wear; excellent overall performance, to ensure a longer bearing life. Molding machine in the process of rotational molding, there is no flow, gates and other waste, the production process is almost no charge back, the product wall thickness is relatively uniform, it can give full play to the effectiveness of materials, so the process for the utilization of materials Very high, is conducive to saving raw materials. Molding machine work process is actually a process control, we all know how to use the rotomolding machine to work better is its highest efficiency? Xiaobian below for everyone to briefly introduce.

Molding machine operation is divided into the following three: that is, manual, semi-automatic and fully automatic. Molding machine equipment is divided into five work areas, mainly: loading area, heating room pre-cooling area, cooling room and discharge area.

The machine is equipped with a wheel, which is used as a fixed mold. The robot is driven by a motor driven along a circular track to each area. Molding machine cycle starting point for the loading area, in this work area to achieve the wheel angle adjustment, so that rotomoulding mold can be safely in the horizontal loading.

The turntable drives the manipulator and the mold to the heating chamber. In the heating chamber, the front end of the manipulator is driven by the gear wheel for two-way 360 degree rotation. The rotomoulding material is sintered and melted in the mold. In this work area to be heated room (oven) temperature control and roulette, automatic rotation of the robot and its rotation direction and rate adjustment.

The rotational molding machine rotates into the precooling zone, where the mold is stationary and the molding of the rotomoulded product is solidified. Molding machine into the cooling zone, the use of wind turbines to cool the mold. The time at which the turntable is staying in each area is set according to the requirements of the process. The use of rotomoulding machine, if used improperly with a certain risk, the following Xiaobian give you about the use of plastic molding machine safety specifications:

WARNING: Disconnect the power supply before performing any repairs to the roller press.

Molding machine

1. Do not tear off the signs on the rotomoulding machine, please contact us if the wear needs to be replaced.

2. The operator should ensure that there are no other unrelated persons in the equipment operating area.

3. Prohibit the operator to climb on the mold, because such behavior is dangerous.

4. In the event of a fire, use a dry powder fire extinguisher with a rating of A, B, and C, because some part of the rotational molding machine is charged.

5. Do not leave the raw material, the raw material that spills the mold in the heating chamber.

6. Do not open the protective device and safety device at will.

7. Do not repair the running mechanical parts.