Zhejiang Anji Tianyang Rotational Mouding Machinery Co.,Ltd

High quality product, professional service, being the core supplier in laser industry!

Home > News > Content
Carrousel Machine Use Safety Specifications
- Aug 15, 2017 -

carrousel machine Use safety specifications

The use of turntable, if used improperly with a certain risk, the following Xiaobian give you about the use of turntable safety norms:

WARNING: Disconnect the power supply before performing any repairs to the turntable.

Turntable

1. Do not tear up the signs on the turntable, please contact us if the wear needs to be replaced.

2. The operator should ensure that there are no other unrelated persons in the equipment operating area.

3. Prohibit the operator to climb on the mold, because such behavior is dangerous.

4. In the event of a fire, use dry powder fire extinguishers of grades A, B, and C, because some parts of the turntable are live.

5. Do not leave the raw material, the raw material that spills the mold in the heating chamber.

6. Do not open the protective device and safety device at will.

7. Do not repair the running mechanical parts.

   The work of the turntable is actually a process control, we all know how to use the turntable to work better is its highest efficiency? Xiaobian below for everyone to briefly introduce.

     The operation of the turntable is divided into the following three: manual, semi-automatic and fully automatic. The turntable equipment is divided into five working areas, mainly: loading area, heating room precooling area, cooling room and discharge area.

Turntable

     The turntable is equipped with a wheel, which is used as a fixed mold. The robot is driven by a motor drive to travel along the circular track to each area. Rotating machine cycle starting point for the loading area, in this work area to achieve the wheel wheel angle adjustment, so that rotomoulding mold can be safe in the horizontal loading.

     The turntable drives the manipulator and the mold to the heating chamber. In the heating chamber, the front end of the manipulator is driven by the gear wheel for two-way 360 degree rotation. The rotomoulding material is sintered and melted in the mold. In this work area to be heated room (oven) temperature control and roulette, automatic rotation of the robot and its rotation direction and rate adjustment.

     The turntable is rotated into the pre-cooling zone, and the mold is stationary in this area, so that the rotomoulding product is solidified. The turntable enters the cooling zone, and the fan is used to cool the mold. The time at which the turntable is staying in each area is set according to the requirements of the process.