Zhejiang Anji Tianyang Rotational Mouding Machinery Co.,Ltd

High quality product, professional service, being the core supplier in laser industry!

Home > News > Content
Carrousel Machine Need To Be Checked Several Cases
- Aug 03, 2017 -

carrousel machine Need to be checked several cases

The turntable can blow the machine oil pot, jug, soy sauce pot and other products, that turntable maintenance and maintenance we know how much, the following press tell you about the turntable usually maintenance and maintenance, hope to help everyone, If there are other problems can also call our phone.

1, feeding level without feeding: need to check several cases,

Whether the hopper has been expected, if it is: need to quickly feeding

Do not: Please check whether the turntable controls the contactor in the energized state. If it is energized, check whether the motor is in power and load, as this is likely to be caused by the preform (embryo) , Then the easiest way is to manually help lift. If you check the turntable control contactor is not in the state of power, please check the preform to check whether the electric eye is not on the same straight line with the reflector.

2, the old card into the feed tray: This situation is a headache problem, from the experience point of view if the length of the preform (embryo) relatively long cut the weight of the larger, then this phenomenon is relatively small.

3, the bottle can not be taken out from the mold after blowing.

First of all, the mold should be opened, manually open and close the mold, if normal, running in the air running state, if it is normal.

Please check your exhaust time setting, if the exhaust is set properly, and each time as long as a blow on the failure, then you can determine the exhaust valve problem, please open the exhaust valve to check the spring and seal (this There is a phenomenon that the exhaust sound is relatively large or no row of the sound of the net).

If you are experiencing a lot of mold production is normal to come about this kind of open can not mold the situation, please check whether the lock pin pin in the inside of the screw, please check the clamping force is too large, if too much should be in accordance with Standard readjustment.

    4, the bottle is always caught injury

Whether the position of the robot is dislocated.

5, two robots collide

This situation requires a manual reset of the robot, which is caused by dislocation

This machine with cladding, liquid level line can blow 5L the following products such as oil jug, jug, soy sauce pot and other products. The use of hydraulic systems, computer control, double-bit blowing, quality and stability.